Self Closing Door Hinges Instructions

Using a hex wrench open the spring so you can see the tension pin.

Self closing door hinges instructions.

You can then remove the hex wrench and allow the spring to naturally unwind. They allow adjustment so the screen door closes securely without slamming. As mentioned previously the door should close smoothly and fully with little noise. Then add or release tension until you get the proper close rate photo 2.

How to install a self closing door 1. Step 2 increase the hinge tension. Screw the spring hinges to the door so that the slotted section on each hinge is on top. Start by removing the locking pin photo 1.

If the door does not close fully then you need to increase the tension. Then remove the pin using pliers. If the self closing door to your garage isn t closing hard enough to latch properly or the door slams shut you can adjust the spring hinge tension with a hex wrench and pliers. Installing a self closing hinge first place the hinges onto the door.

A spring loaded hinge should only be removed when the door is closed to avoid it slamming. Insert a hex wrench into the. Self closing hinges take the place of regular hinges. See if they line up with the nail indents from the previous hinges.

Remove the locking pin. You may have to chisel the edge of the door to get a new square cornered hinge to fit in mortises machined for round cornered hinges. Ask a friend to hold your door in. In order to tighten the hinge spring first close the door.

If the holes align you can simply attach the hinge using the screws it came with. Unscrew the locking screws from the top hinge. Refer to the specifications that came with your hinges to determine how many spring hinges you need. I ll bet that you never knew you could adjust a self closing door hing.

Check the top of the hinge to see if it has a screw which protects. When you properly attach the hinges to the outside of the door and. Changing tension with a hex wrench 1. If the door closes fast and with a bang you need to loosen the hinge spring tension.

If you re using one spring. If you plan to use self closing hinges take the original middle hinge to your home center or lumberyard and find self closing hinges with plates the same size as the ones already on the door.