Should Metal Roof Overhang Drip Edge

If the gutter is lower than the bottom edge of the drip edge install flashing behind the drip edge and over the back edge of the gutter to remove the gap.

Should metal roof overhang drip edge.

A drip edge is a metal usually aluminum strip which extends beyond other parts of a roof and directs rainwater off the roof away from the fascia and into the gutter. On 2020 02 20 by chuck. It has the main function of controlling water flow on the roof which has many implications. Drip edge profile types.

When used as a drip edge it should be a minimum of 0 69 mm or 20 ounces. Drip edge is a metal flashing that tends to overhang the sides of a roof. Some slight overhang is recommended in conjunction with a drip edge flashing to prevent water from getting under the roofing and onto underlying wood. There is a small size metal rim facing outwards and away from the roof fascia.

Slightly out of perfect flat probably isn t going to make a noticeable difference. If the overlap is too short fix it by placing drip edge under the first row of roof shingles and be sure that the exterior edge is reaching over the gutter. A typical metal roof overhang may be 2 to 4 inches or even less. Too little can allow water to seep into rake or fascia boards.

If it s not that i suspect it was not properly nailed or was bent or damaged during installation. Copper is a sturdy metal that gives a roof a unique look. Metal is usually installed on rafters or strip sheathing rather than the solid decking used under other materials. Although it does not look like much this component is made to have great structural integrity.

Most homeowners will trust their roofing contractor to do what s necessary to replace the old roof but it doesn t hurt to ask if your roof bid includes drip edge. Too much overhang and the shingles could blow off in high winds.